Tiger 1 Commanders Hatch

[Red Devils]

Calling all fellow rivet counters,

I'm looking for a pic of the commanders hatch support arm. I have read on other modeling sites that there is a weld seam that runs throught the middle on the outside edge on the Mid/Late Prod cupola of this arm. The pics I have/seen are to far away to confirm. I'm hoping that someone out there close to all these actual museum pieces may have a great close-up shot. Thanks in advance...

Derek

P.S. Still looking for spare Loaders Hatch Hinge, Sprue G, Part #3 from the 56010 kit. Anyone...

[Wildboar44]

Hey Red ............

dont know if this helps ?

[Red Devils]

Thanks buddy, it does. Much appreciated...

Derek

[doc larsson]

when i looked at that pic i thought someone had went too far in detailing.... then looked again and saw it was a real kitty !