Fixing nylon g/box bearings in

[Miggers]

Since converting the 'boxes to 3 to 1 the Tiger has performed superbly
until the other Sunday when it threw the right track .

Upon examination,the only thing I could find was a lot of "float" in the RH box's
output shaft.
I haven't stripped it yet but I suspect it's the outer bearing come loose.

Can I fix it into place with epoxy resin(might as well do the LH while it's apart)?
Sure I read somewhere that epoxy wasn't ideal?

Cheers,Mark

[tankman]

Hi Mark I've used superglue to fix my HL Gearbox bearings in place. Also seen them soldered in as well. Hope this helps
Alan

[Miggers]

I superglued 'em in to start with Alan.
Superglue(or cyano for our U.S readers)tends to be strong but brittle.
I either didn't use enough glue or the stuff I've used(supposed to be industrial)
isn't strong enough,that's why I wondered about epoxy.

Mark