Well onward we go. I had made measurements and marks, I hope it pans out because there's epoxy and CA glue already in play. We shall see...HERMAN BIX wrote: ↑Sun Aug 17, 2025 11:59 pm Time zone delay !
Yes yes you need to remove the left overs from the sides of the hull.
Too late now but recording a measurement centre to centre of the stock idlers is also important.
Not all adjustable idler mounts are created equal !!
Just dry fit one into position and check that it’s close to the centre line of your road wheels.
I have used a jig and a felt tip to mark the holes and either works.
24 hours later we will see...
In the mean time doing the vent screens is quite a bit more of a pain in the a55 than I had been led to believe. I did actually try to remove the ducting as it was shared previously that they were easy to pry off. Nahhh EVERYTHING on this thing is over glued to the max. I used the big razor wedge to pry all sorts of sections but alas it wouldn't let loose. So I just worked with it. I'm on the fence with the louvers but likely not.
making the rear panel whole again and dare I say more solid than it came out of the box. At the very least all the panels and such line up properly and everything fits together snugly.
