Help with anti-slip hubs

[Sub]

Hi,
check out this thread here it might help, this is what i did for my Challenger yrs ago.

Sunhttps://www.rctankwarfare.co.uk/forums/viewtopi ... 41&t=25984

Sub.

[Neil64]

Hi subs I see you made your own slip rings for the original drive hubs , do you fancy making some more I am happy to pay ?
Well I did file the new hubs teeth still could do with more work but it's 90% better than it was I can now run on rough ground
I may in the end upgrade the lot and just put all new on , my wife wants the Abrams I hope this is better than the challenger

[Sub]

Neil64
Thx for the offer but i only build for myself, however check out this link they may fit Challenger hubs, contact Dave and ask him if he is willing to check if they could fit the Chally 2 sprocket hubs.

https://www.forgebeartanks.com/store/p3 ... Scale.html
You never know, the Leo 2 and chally 2 drive train is very similar.
Hope its of use.
Sub.

[Neil64]

Hi Sub thanks I sent him a message , I did file the teeth on the new hubs and it's a loads better so thank you everyone for your help, I didn't know there was so much to tanks , I have CP helicopters , and off road racers but very new to tanks so have a lot to learn

[Meter rat]

They do not fit.

Despite my post on assisting newbies. I may have a set of inducers, if I can find all the parts. I took them off my Challenger when I widened the sprockets and have not needed them since. I will try to find them, or a link to Challenger sprockets with them.