Herr Doc's Various Questions

[Herr Dr. Professor]

Rather than butt in on others' threads or start a new thread each time, I am going to use this thread for my questions. I have so many.

[Herr Dr. Professor]

Despite two hours of searching here on RCTW and on the web generally, I cannot find the name for the type of connectors now used by HengLong for the TK6.0-7.1 MFU to motors. Are these "bullet" connectors? (Licmas of Germany sells the appropriate connectors, but the cost of posting them would be silly, epecially since I can likely find them here in the U.S. and I would not hesitate to solder them if even needed. Nonetheless, here is the photo from Licmas):

Motoren-kabel-heng-long-v6-0-v6-0s.jpg (17.36 KiB) Viewed 1936 times

[Herr Dr. Professor]

I hope soon to start on my WCP (Will and Catherine's) SdKFz 251. I have been saving information, and found this photo in my file on the SdKFz 251. I have one of these, but it will be quite large to hide, and it may be a bit "overkill" for the use. Do you have any advice?

Dual Esc.jpg (92.91 KiB) Viewed 1936 times

[Tanker1966]

How bout these:
https://www.motionrc.com/collections/mo ... connectors

[jarndice]

I hope soon to start on my WCP (Will and Catherine's) SdKFz 251. I have been saving information, and found this photo in my file on the SdKFz 251. I have one of these, but it will be quite large to hide, and it may be a bit "overkill" for the use. Do you have any advice?

Dual Esc.jpg

That looks very big for the work you want it too do, I went to E-Bay and bought a "2 way 18a x 2 mixed brushed ESC Speed Controller" It gives 4 channels plus 2 separate motor connectors + a Power connector,
it is 3.5 cm x 2 cm x 3mm the longest of the 5 connector cables is 16 cm long,
The seller is "zh20it" and it cost me £13.01,
I believe they now sell the same ESC but smaller,
If you go to his site you will see a very wide range of his products,
Hope this helps,

[Jofaur86]

Good evening Mr.pofessor, following the photo on your cords? Have you looked in an auto accessories store? seems to be the same as the Tamiya motor and DMD sheets?

IMG_4298.jpeg (69.58 KiB) Viewed 1902 times

These are “Japanese” type terminals

[Jofaur86]

For your ESC I am of the opinion of "Gardening" this one is more of a type for RC cars, 320 Amps? seems excessive to me, personally 30 A seems sufficient to me? Afterwards, I'm not an ESC specialist, but even on some electric racers, they weren't used that big?

[Meter rat]

These are what you are looking for..
https://www.vehiclewiringproducts.co.uk ... connectors

[Herr Dr. Professor]

Thank you, Tanker 1966, jarndice, Jofaur86, and Meter rat: I will use the links provided to get a clear ID of the exact term for the connectors, and you have confirmed my feeling that the ESC is overkill and oversized for my purposes. I'm glad to have a potential source for a smaller "mixed" ESC.

[Ludwig von wigbearer]

bought these on ebay