Tamiya Tiger 1 top deck.Obtained.Many thanks.

[John Glover]

Merry Xmas to all tankers. Does any one have one of these that is junk or parts of one they have already destroyed or cut up .Regards John.

[sassgrunt]

There's this one on eBay, but I don't know what the shipping would be to get it to you. https://www.ebay.com/itm/296549314234?_ ... R7r_qdmAZQ

[John Glover]

Thank you Mike, but was hoping on the off chance that some one had a rubbish one or parts from a destroyed one as trying to get the radiator round caps x 2 that are molded to the deck. Just another small Initial Tiger 1 feature. They did not have rectangular reinforcement plate around the caps so if I can get the two sections of knacked deck that have these then some, carful scaping, cutting and sanding will allow me to install this feature on to my build. Regards John.

[Meter rat]

I may still have half the deck, I cut out of the Hobby Boss if it is any use?

[HERMAN BIX]

I have a hobby Boss Tiger as well.
I will have a look at the engine deck tomorrow & see if its going to work.

[John Glover]

Thanks' for the reply's guys. Thanks you again Meter rat for the Hobby boss pieces that include the radiator caps but unfortunately the Hobby boss radiator caps are smaller than the Tamiya's ones. Hobby boss is a no go. Thanks again. John.

[John Glover]

Thanks' for the reply's guys. Thanks you again Meter rat for the Hobby boss pieces that include the radiator caps but unfortunately the Hobby boss radiator caps are smaller than the Tamiya's ones. Hobby boss is a no go. Thanks again. John.

[tomhugill]

Hey John I've got one that's slightly butcher but may fit the bill, I'll check over the weekend

[John Glover]

Thank you Tom. Looking forward to hearing from you. regards John.

[sassgrunt]

I don't know if it'll help, but I sent you a PM.