Tongde Centurion servo setup question

[Ace Rimmer]

Hi Lee,

Thank you for the info....this is the recoil I have...

Mark

[Ace Rimmer]

This is what I'm trying to achieve...mk2 early version with 17pdr gun

Ace

[Exhibitedbrute]

Interesting that you are doing the mk2 I’m doing a mk2 but mine is the Ludwig kit

[Ace Rimmer]

Interesting that you are doing the mk2 I’m doing a mk2 but mine is the Ludwig kit

I had a spare barrel from a sherman firefly I am building so thought why not

Ace

[Jofaur86]

Hello, I don't want to say anything stupid, but the gun recoil is on the J2 plug at the bottom right, the black wire of the servo cord towards the outside of the board, I don't know this card? but personally on a TK 22/24 I needed to program it with the famous TV button control? There was only one plug that worked, from memory? Is the switch the Flash command? ( to be checked )

[Ace Rimmer]

Hello, I don't want to say anything stupid, but the gun recoil is on the J2 plug at the bottom right, the black wire of the servo cord towards the outside of the board, I don't know this card? but personally on a TK 22/24 I needed to program it with the famous TV button control? There was only one plug that worked, from memory? Is the switch the Flash command? ( to be checked )

Hi, this is on the stock tongde board which has 2 servo plugs.....unfortunately the recoil isn't powered but the elevation is. As for the clark board I have the Centurion from Andrew Haya...just wanted to test the recoil before I began to fit it back into the tank.

Ace

[Jofaur86]

I admit to being lost? the photo in the diagram is indeed a Clark TK 50, what is the original "Tondge" card? Is the reverse output not powered? tried reversing servo plug? see if inserted in the right direction?

[Ace Rimmer]

I admit to being lost? the photo in the diagram is indeed a Clark TK 50, what is the original "Tondge" card? Is the reverse output not powered? tried reversing servo plug? see if inserted in the right direction?

It's the recoil on the main cannon I'm trying to test....it seems the tongde board has the servo ports but only the elevation port has power....the recoil servo port is not powered. I'll take a pic of the board and post it later
I haven't wired the clark board yet, wanted to get the servo rest position right before attempting to attach the barrel as it could be too far in or out of the mantlet.

Ace

[Ace Rimmer]

Interesting that you are doing the mk2 I’m doing a mk2 but mine is the Ludwig kit

Hi, I built a ludwig Cromwell a few years back.....the quality was excellent.....what board are you going run it? The clark board from Haya?

Ace

[Exhibitedbrute]

It was going to be ibu but now it will have to be Clark’s. I’m also building a Cromwell that’s annoying me and I have a crusader