Coolbank M5A1 stuart!

[tankme]

Ecam is correct. They are grousers. They bolt onto the tracks to add traction in mud or snow.

[JohnWhyte]

Ecam is correct. They are grousers. They bolt onto the tracks to add traction in mud or snow.

I wasn't sure what they was only that they was part of the tracks so thanks

[tankme]

They use the hollow sides of the M5 track pins to insert in the ends:

https://www.milweb.net/webvert/99710

[Kaczor]

One note - Stuart was equipped with 34 grousers in total (mounted on every 4th track) so there weren't probably enough of them to cover the hull like this

[JohnWhyte]

One note - Stuart was equipped with 34 grousers in total (mounted on every 4th track) so there weren't probably enough of them to cover the hull like this

Yeah but you don't know how many was either borrowed or acquired from other tanks bit like the extra wheels and tracks used as extra protection

[Kaczor]

As I suspected, the problem is not the transmission but the electronics. I connected the Beier to the test and immediately the model runs slower

phpBB [video]

[Ad Lav]

Nice

[tankme]

As I suspected, the problem is not the transmission but the electronics. I connected the Beier to the test and immediately the model runs slower

phpBB [video]

Good to know. Did you sand the Chevrons down or just run the hell out of it on concrete?

[Kaczor]

Good to know. Did you sand the Chevrons down or just run the hell out of it on concrete?

Nah, it's just optical illusion. But when they are worn off, I will glue on rubber pads

[RKRC]

I need help how did you get it apart I can only see two screws at the back??