Newbie

[Ruzzz]

I'm sure you will be getting members a bit like myself given the season.
I'm Russ ( 58 ) an electronic engineer from Southampton in the UK.
Ive recently got a 3d printer ( a creality K1 ) and have started on https://cults3d.com/en/3d-model/various ... k-rc-model
( Wish me luck )
I hope you will treat me kindly when I ask stupid or obvious questions, and I hope I can help with electronic and arduino questions.

[MrChef]

Welcome to the forum Ruzzz. I know absolutely nothing about these magical, mythical things called 3D printers.

But there are knowledgeable helpful members here.

Best luck

[Meter rat]

Hello and welcome from the West Coast of Scotland. Electronics, witchcraft. 3D printers, witchcraft. You cannot ast the stupid or obvious questions. That is my domain. So but off.

[ColemanCollector]

Welcome from Ontario, Canada! New 3D printer guy here, too. I have a couple of good prints under my belt, and today's refused to cooperate. The learning, fun, and dumb questions begins!

Mike.

[Herr Dr. Professor]

Greeting, Ruzzz, from across the puddle in Wisconsin, US. There are all kinds of 3d Wizards here on RCTW--not me, alas. And when it comes to "stupid or obvious questions," well, these folks have been kind and patient with me for years. Dive in!

[BarryC]

Welcome sir!

You sure to find answers to your questions.

Barry

[Son of a gun-ner]

I hope you will treat me kindly when I ask stupid or obvious questions,

Hey, I used to ask dumb stupid questions, now I help run the place

Anyway, welcome to the forum Ruzz
And no, you're not a typical new member type at this time of the year, the usual type have just purchased a new tank with problems, ask a few questions, get answers, rarely say thanks and are never seen again.
It's almost like Mr Creosote has eaten them alive, just don't give him a wafer thin mint to find out