RC 1/16 Bren Carrier revisited

[jee]

Hi Jaap, these ones
https://www.ebay.co.uk/itm/224917215011 ... 3789119644

there are about 10mm square by 25mm long 6v 200rpm

Alwyn

Thank you!

[AlwynTurner]

Just about finished the major superstructure






Lots of detailing still to do.

Alwyn

[HERMAN BIX]

I will be having one of these to do the captured version if you don’t mind !
Will need the accessories for it though if you can be bothered ?

[AlwynTurner]

That won't be a bother at all, it's just the rocket tubes added to the back I think, but I'll check if there's anything else.

Alwyn

[Ecam]

If you do decide to dip a toe in the water then look at the creality printers as a starter, some of the other brands leave much to be desired plus there are plenty of spares, add ons, and teaching vids for the Creality stuff.

Alwyn

Ok, I've been looking for a few days. I think a good starter for me is the Creality Ender 3 v2. I did start to read the 3D printer thread, but by the time I get through it, I will have had two more birthdays. What material would you suggest starting with? Like you, mostly suspension pieces, wheels, hatches and the like for tanking.

[AlwynTurner]

I use pla plus filament. It's very strong and easy to work with. Only down side it can warp if heated. I suggest watching a rew beginners videos on setting up and using a creality printer.
Alwyn

[AlwynTurner]

Some detailing on the front cab




Moving along steadily
Alwyn

[c.rainford73]

Looking spectacular Alwyn. It would make for a good little tank for someone to purchase the stls and print.

[AlwynTurner]

Thanks Carl, there's still a lot of design to do and the prototype to build and get working before the stls will be available, but it will be a cute little rc tank. As a piece of random knowledge, more of this tracked vehicle were produced than any other tracked vehicle ever, which says a lot for the utility and versatility of this vehicle and the genius of its designers.

Alwyn

[AlwynTurner]

More design progress





Still a great deal of detailing to do but moving in the right direction, the main body is almost design complete, it's mainly down to detailing
Alwyn