1/12th Scale Stug...

[Spinnetti]

Well, with the Hetzer Pretty well done (except cammo and a few acessories), I've decided to start the next one, the Stug III. Not in a huge hurry, but will peck away at it. As usual, I start with a known dimension - the tires, and scale everything off that. As usual, with every part I make, I go back and tweak/refine what's gone before, so this is a first draft of the road wheel assembly. No doubt it will get plenty of tweaks before I'm done.

[c.rainford73]

What type and size printer does it require to make such large prices of armor?

[Spinnetti]

What type and size printer does it require to make such large prices of armor?

Ha! Well, you can break it up in however many pieces are needed to fit. I use a PRUSA for most stuff, a Mars and/or Saturn for the higher detail stuff, and a Chiron for the hull and superstructure, which for the Hetzer prints in a single piece (16" or so bed)

[RiskyR]

Oh yes! I'm definitely going to follow this one. Looking forward to see your designs and thoughts on this tank.