1. take your Transmitter an turn it on.
2. take the receiver and turn it on
3. take a servo and plug it into channel 1
4. look which stick or switch let move the servo
5. do this in sequence with all channels
then you know which stick and switch
which channel is assigned
does this agree with the instructions?
does it not fit, then plug the channels in the appropriate order to the IBU.
which channel / function belongs to which input
is described in the instructions for IBU
jhamm wrote:
4. look which stick or switch let move the servo
5. do this in sequence with all channels
then you know which stick and switch
which channel is assigned
This is a i-bus connection.
it would have been good to have had this information beforehand.
Because this, i think there will be an error in the IBU configuration.
Did you know the IBU Manual? http://www.ibu-electronics.com/doc/IBU2 ... h_V2-3.pdf
Look at "Getting Started" and do all steps again..