Taigen V3

[Jofaur86]

Hello
Following the purchase of a Taigen V3 type module,to replace the original RX 18,and use wiht a conventionel radio (Flishky FS6 T ) as indicated? nothing happens and moreover no help,thank king you in advance good day.
PS: no explanatory note

[Jofaur86]

Hello,
No one hase the answers or already had this problem

[john1970]

If you understand German

https://www.youtube.com/watch?v=8jX2BIEEt98

[tomhugill]

Hello,
No one hase the answers or already had this problem

Did you put the little bind plug in?

[Jofaur86]

OK,thank you for the answer but that doesn't tell me why the deck doesn't power the RX? While the fan is running

[Jofaur86]

Tomhugill
Yes

[Jofaur86]

I do not understand ? Already watched this vidéo,they use a RX Flysky ,but a Taigen transmitter

[john1970]

[Jofaur86]

Thank you for diagram !! I have to connect according to diagram??but my concern is that the fan turns ?and that on my receiver the led does not ligth ? up and that everything works, with servos ? Moreover i do not understand that on the vidéo?a Taigen transmitter is used so I would like to know if it works with a radio set other than Taigen ? And why my RX does not turn on

[john1970]

connect as in diagram put in your transmitter selection plug number 1 in diagram your rx should be power by the taigen board as it says it has a built in bec if not then i dont know