Ok, will start for that easy exercise. I have a fully programable transmitter.Rad_Schuhart wrote:I guess it will take you some time until you figure how that works, but be patient. I suggest you start with an easy thing, like Prop 2 Input RC, Prop 2 Type Function 1/2. +100 of the signal will trigger the selected function, -100 will trigger the other.
Prop2 on "Function 1/2" type, set up on a RC channel linked to a 3 position switch, outputting -100,0,100. Position 1 as "A11 on/off". Position 2 as "A10 on/off". A picture would be better:
So A11 will light on and off if switch is moved from center to top, and A10 will do the same when switch is moved from center to bottom. Well... A11 does, A10 don´t. I have to cycle through A11 again to light off A10. Servo monitor on transmitter clearly shows -100,0,100. Is this a normal behaviour?