. I am currently 3D printing a T35A Russian Tank. So if anyone has any advice on how to make the Turrets work and the type of radio system, all help would be appreciated. Kind regards
Oscardog
Just saying hello
Just saying hello
I have just joined and this is to say hello to everyone . I am currently 3D printing a T35A Russian Tank. So if anyone has any advice on how to make the Turrets work and the type of radio system, all help would be appreciated.
Kind regards
Oscardog
. I am currently 3D printing a T35A Russian Tank. So if anyone has any advice on how to make the Turrets work and the type of radio system, all help would be appreciated. Kind regards
Oscardog
-
Son of a gun-ner
- Lieutenant-Colonel
- Posts: 7593
- Joined: Sun May 07, 2017 8:49 pm
- Location: Lancashire UK
Re: Just saying hello
Hello and welcome to the forum Mr Oscardog
Are you intending to print the whole tank?
It may pay you to look at this.
3D Printed T-35A - RC Tank Warfare
viewtopic.php?f=33&t=24871
Are you intending to print the whole tank?
It may pay you to look at this.
3D Printed T-35A - RC Tank Warfare
viewtopic.php?f=33&t=24871
Mick - The grit in the underpants of life!
Always happy to spare the bytes
Apparently my mind works in mysterious ways
TOTM needs YOU
support YOUR TOTM competition, I'm doing my part, are YOU?
Always happy to spare the bytes
Apparently my mind works in mysterious ways
TOTM needs YOU
support YOUR TOTM competition, I'm doing my part, are YOU? -
c.rainford73
- Major
- Posts: 6104
- Joined: Thu Aug 25, 2016 7:34 pm
- Location: Connecticut USA
Re: Just saying hello
Hi All
Yes I have seen them and I am about to finish the hull, but need help in where all the servos go and how to install them. will put up some photos when I work out how to do it
Oscardog
Yes I have seen them and I am about to finish the hull, but need help in where all the servos go and how to install them. will put up some photos when I work out how to do it
Oscardog
