Building a Mid-Production Normandy Tiger 1

[Michlss]

my english is not good, do it with translation

[Wildboar44]

Can I ask for a Moderator to move this build back into Heng Long section. It has somehow moved into General Questions. Thank you .

[HERMAN BIX]

Done.
I had another "holy crap I banned Mick" moment
Now repaired sorry.

[Wildboar44]

Done.
I had another "holy crap I banned Mick" moment
Now repaired sorry.

Thanks Mr BIX

Hello Michlss, the author of this Tiger 1 build has not been on the forum for a while. Perhaps Tim will reply to your question but im not sure. The hatch rail is very thin, I would bond both brass arms to some 0.5mm plastic styrene card, then glue this into a base plate also made of styrene. Aber instructions just say bond both parts together after bending one to the left and one to the right at the bottom of each part. See drawing attached

Hallo Michlss, der Autor dieses Tiger 1 Builds ist schon länger nicht mehr im Forum. Vielleicht antwortet Tim auf deine Frage. Die Lukenschiene ist sehr dünn, ich würde beide Messingarme mit einer 0,5 mm Styrol-Plastikkarte verbinden und diese dann in eine ebenfalls aus Styrol gefertigte Grundplatte einkleben. Aber Anweisungen sagen einfach, binde beide Teile zusammen, nachdem du jeweils einen nach links und einen nach rechts unten gebogen hast.
Siehe beigefügte Zeichnung

This may answer your question /
Dies kann Ihre Frage beantworten

Hope that helps (All translation by Google)
Ich hoffe, das hilft (Alle Übersetzungen von Google)

[Michlss]

Hello wildboar44,
Thanks for the instructions and the drawing helped me a lot.
Thank you

[MrChef]

What an amazing build. It's a shame there's no completion. I hope TFTM well and successful musical careers to his sons.