I'm up grading one of my tigers that has that A,B,C channel switch to a rx-13 board but i can't see where the motors attach on it.
I've looked at the rx-14 pictures but it's a diffrent layout.
can any one help.
Tackleberry
RX-13 Digram needed
-
Tackleberry
- Recruit
- Posts: 37
- Joined: Tue May 05, 2009 5:50 pm
- Location: Welling- Kent
RX-13 Digram needed
Hello
I'm up grading one of my tigers that has that A,B,C channel switch to a rx-13 board but i can't see where the motors attach on it.
I've looked at the rx-14 pictures but it's a diffrent layout.
can any one help.
Tackleberry
I'm up grading one of my tigers that has that A,B,C channel switch to a rx-13 board but i can't see where the motors attach on it.
I've looked at the rx-14 pictures but it's a diffrent layout.
can any one help.
Tackleberry
Re: RX-13 Digram needed
here is a picture of the underside of an rx board from Whacky's guides,
the RX #13 and #14 use the same PCB but have different components on them and the motor wires connect to the board in the same place excepting the fact the #13's wires are soldered and the #14's are plug connections.
the RX #13 and #14 use the same PCB but have different components on them and the motor wires connect to the board in the same place excepting the fact the #13's wires are soldered and the #14's are plug connections.
Last edited by BREL on Tue Jun 30, 2009 5:54 pm, edited 1 time in total.
-
Tackleberry
- Recruit
- Posts: 37
- Joined: Tue May 05, 2009 5:50 pm
- Location: Welling- Kent
Re: RX-13 Digram needed
Thanks BREL
it was a good help and i didn't blow it this time
Tackleberry
it was a good help and i didn't blow it this time
Tackleberry
