New Taigen V3 MFU Installation

Ghosttjr · Post by **Ghosttjr** » Thu Oct 04, 2018 3:32 pm

Video of me installing the new V3 MFU/Board

https://www.youtube.com/watch?v=K9zn4n7-WM8

jarndice · Post by **jarndice** » Fri Oct 05, 2018 4:03 am

Excellent demonstration of a job very well done,

Might I offer a tip,
I always glue a precut sheet of Male "Velcro" on the floor of every Tank I build and I glue a female patch of "Velcro"to the underside of the Battery, the Control Board, the Speaker, the Smoker, the Receiver or in this case the Sound Module,
Whatever kind of ground you operate your Tank on everything stays in place BUT everything is easy to move or remove when necessary.
After all just think of the mayhem inside your Tiger 1 if you had accidently reversed it into the Tank Trap/Sink behind it

Ghosttjr · Post by **Ghosttjr** » Fri Oct 05, 2018 5:14 am

I have that Velcro (the sticky one)and use it allot, didn’t think of it at the time, but when I got the old board out I did unscrew the smoker and Velcro it so I don’t have to unscrew the electronics plate when the smoker fails.
The new board cleaned up the wiring a little. Now waiting for the sound card with the Tiger sounds.
The proportional turret is great, the sounds too! And the anti track recoil is build in!
Thanks for your reaction and greetings from the Netherlands ; p

Verzonden vanaf mijn iPhone met Tapatalk

Post by **HERMAN BIX** » Fri Oct 05, 2018 1:04 pm

Yeah thats a great job. I hope mines the same.
Thanks for the video, it could be quite helpful.

Ghosttjr · Post by **Ghosttjr** » Fri Oct 05, 2018 4:07 pm

HERMAN BIX wrote:Yeah thats a great job. I hope mines the same.
Thanks for the video, it could be quite helpful.

I hope this will help you

https://www.taigentanks.com/taigen-part ... /tag120605

Verzonden vanaf mijn iPhone met Tapatalk

RC Tank Warfare community hobby forum