Heng Long Leopard 2A6 and IR recoil

[leopardgreece]

Hello. I have a HL Leopard 2A6 airsoft 2.4GHz.The volume and smoker control are on the radio (2 buttons). I have a Taigen turret IR with barrel recoil and muzzle flash assy.Its complete with wires/plugs and modules (Tiger turret).Will these systems work with the main board and radio that the Leopard has already? I just want to be sure that i will have not to change the main board and the radio. Thank u.
Panos from Greece. Panos from Greece.

????? ?? SM-P605 ???????????? Tapatalk

[leopardgreece]

Also i have one of this number 1 top hull connector

????? ?? SM-P605 ???????????? Tapatalk

[leopardgreece]

????? ?? SM-P605 ???????????? Tapatalk

[wibblywobbly]

The transmitter is unlikely to work as far as I know, the HL and Taigen are both 2.4ghz, but they operate their own systems under different frequencies. It would be much better to get a matching transmitter and RX18. You will need to bind the RX18 to the transmitter.

[Jay-Em]

If You have bóth the Heng Long 2,4 ghz transmitter and the Heng Long 2,4 ghz RX18 receiver/controller module, the whole Taigen affair can be plugged in the Heng Long RX18 the same as it is plugged in the ori Taigen. I successfully switched a Taigen Jagdpanther to an older generation Heng Long 2,4ghz unit. (Hated the rattling, shrill sound that attempts to be an engine simulation, though, so I put an IBU2 in it...)

There is, however, òne tiny difference. Somewhere in the big flat plug that goes to the turret motor and stuff, there are 2 pins switched. I believe it’s pin 5 and pin 2 -not really sure. Cannot remember which ones exàctly- browse the technical part of the forum for a bit, and You’ll run into it.