![Clapping :clap:](./images/smilies/icon_clap.gif)
![Clapping :clap:](./images/smilies/icon_clap.gif)
Loving this build capt.midnight , looks good in the pics and even better in person
![Waving :wave:](./images/smilies/icon_wave.gif)
That's basically what I've done on these. All the pins except for the ones on the plates at the front of the screens are acting as rivets. The top ends of the turret brackets are pinned, and the bottom ends will be glued in place from the inside. I might put a pin on the inside just to kind of help hold them in place.c.rainford73 wrote:Bill this looks fantastic! On an earlier project Panzer IV with turret schurzen I was going to CA glue the brackets to the turret and decided to install small pins and carefully drilled the turret with a very fine drill bit to secure the schurzen mounts with the addition of CA glue. Basically I "bolted them down" to secure them