What tools do I need to work on my RC Tank

foxtrotraptor · Post by **foxtrotraptor** » Thu Jul 06, 2017 1:36 am

Hello so I noticed I ran into a problem when I was opening my king tiger, I have a small set of screw drivers but the set I have is a bit short and the base is too wide to fit in to reach the screw and get it ot. I noticed on youtube a few poeple use a screw driver that is long and slim and has a Orange T handle. That would be perfect to work on my tanks but I havent been able to find any of those other than in a Hex style. anyone know where I can get these or better yet a link to purchance one, I looked on amazon but I havent had much luck.

much appriciated

Wolverine Tanker · Post by **Wolverine Tanker** » Thu Jul 06, 2017 3:09 am

Go to Harbor Freight. They should have a similar one in stock.

foxtrotraptor · Post by **foxtrotraptor** » Thu Jul 06, 2017 3:29 am

oh your right, I have one that is not too far from where I live. Ill take a look. Thank you

RobW · Post by **RobW** » Thu Jul 06, 2017 12:33 pm

If you avoid the changeable head style screwdrivers you should be fine. Magnetic ones are very useful for getting the screws in around the gear boxes.

foxtrotraptor · Post by **foxtrotraptor** » Thu Jul 06, 2017 10:53 pm

I looked but I didnt have any luck. EVerything was too big

PainlessWolf · Post by **PainlessWolf** » Thu Jul 06, 2017 10:58 pm

Good afternoon,
www.micromark.com
regards,
Painless

foxtrotraptor · Post by **foxtrotraptor** » Thu Jul 06, 2017 11:06 pm

PainlessWolf wrote:Good afternoon,
http://www.micromark.com
regards,
Painless

Ph awesome very helpful thank you sir

RC Tank Warfare community hobby forum

What tools do I need to work on my RC Tank

What tools do I need to work on my RC Tank

Re: What tools do I need to work on my RC Tank

Re: What tools do I need to work on my RC Tank

Re: What tools do I need to work on my RC Tank

Re: What tools do I need to work on my RC Tank

Re: What tools do I need to work on my RC Tank

Re: What tools do I need to work on my RC Tank