Finally installing the IBU3 and now
I'm currently converting my MK 3 Pro to be used on the IBU3.
Fan wires to SMP and heater wires to SMR. Yes?
Also, is it safe to use a voltage regulator between SMR and the TARR's heating element? How high of a voltage is safe?
Thanks
IBU3 with TARR MK 3 Pro
Re: IBU3 with TARR MK 3 Pro
Hello,
The wiring as you said are correct, fan wires to SMP and heater wires to SMR.
TARR MK3 is designed to run at 2S Li-Po, if you don't exceed 8.4V can run as is.
If you plan to run 3S Li-Po there's a risk to overheat the heating element, in this case a step down voltage regulator should be used.
Regards
The wiring as you said are correct, fan wires to SMP and heater wires to SMR.
TARR MK3 is designed to run at 2S Li-Po, if you don't exceed 8.4V can run as is.
If you plan to run 3S Li-Po there's a risk to overheat the heating element, in this case a step down voltage regulator should be used.
Regards
