3D Printed Dragon's Teeth

3 posts • Page 1 of 1

Post by OnTrack » Fri Apr 07, 2017 7:40 pm

I printed these up and with a little primer, some wire, and Tamiya pigments I thought they turned out well.

BarryC: 2nd Lieutenant; Posts: 2491; Joined: Sun Jan 03, 2016 11:43 am; Location: Savannah, GA. USA

Post by BarryC » Fri Apr 07, 2017 7:57 pm

They turned out nice, very convincing.

Barry

"Details make perfection, and perfection is not a detail."
Leonardo Da Vinci

OdysseySlipways: Recruit; Posts: 45; Joined: Wed Aug 15, 2012 6:47 am

Post by OdysseySlipways » Sat May 06, 2017 5:18 am

are these scaled down from real ones or are these something you came up with that just fits?

Post Reply

3 posts • Page 1 of 1