Clark and TARR with Taigen 2.4 radio
-
lifeofbrian
- Lance Corporal
- Posts: 113
- Joined: Sat Dec 24, 2016 8:09 pm
- Location: Surrey, UK
Clark and TARR with Taigen 2.4 radio
Am I right in thinking that, if I get a Clark tk24 board and a TARR mk3 or 4 smoker that even with the stock Taigen 2.4 radio, I will still get proportional smoke, drive, turret rotation and separate gun barrel up and down movement, neutral gear and two machine guns? Or would I need to upgrade my radio?
Last edited by lifeofbrian on Sun Jan 22, 2017 9:33 pm, edited 1 time in total.
Taigen Panver IV F2 // Taigen Pantiger
-
Rad_Schuhart
- Warrant Officer 1st Class
- Posts: 2089
- Joined: Tue Jan 19, 2016 9:22 am
- Location: Spanish living in Graz, Austria. Heart in UK.
- Contact:
Re: Clark and TARR with Taigen 2.4 radio
You need another radio.
My RC tanks website, loads of free info for everybody:
https://radindustries.wordpress.com/
https://radindustries.wordpress.com/
Re: Clark and TARR with Taigen 2.4 radio
Not quite, the Taigen receiver (rx) is built into the MFU and uses Taigen's own protocol. The Clark board has no receiver built in so you can plug in any 4+ channel receiver (and matching radio). To run the Clark, then, you need a separate radio/receiver (Tx/Rx) set as your Taigen radio/receiver/MFU is redundant as far as the Clark board is concerned.lifeofbrian wrote:Am I right in thinking that, if I get a Clark tk24 board and a TARR mk3 or 4 smoker that even with the stock Taigen 2.4 radio, I will still get proportional smoke, drive, turret rotation and separate gun barrel up and down movement, neutral gear and two machine guns? Or would I need to upgrade my radio?
