T90 board into Tiger 1 question

[c.rainford73]

It's really nice Herman sounds too good for this basic Grey Tiger

[c.rainford73]

Best part of this is I will have a good starting point for my next project and the sound is the last part to worry about for a change...

[Tiggr]

I will compare your pictures with my Taigen Tiger after work.
It would seem as though we are dealing with wires 3,4 & 5 in the 8 pin socket - getting them in the right order.

[c.rainford73]

We may have to source a picture of your upper hull connector or one like it to compare. I'm sure someone posted a diagram or two of it on here already. As I look at the tigers wiring it looks as If this shouldn't be this hard to do perhaps I'm just missing something simple.

As you look at the newest 8 pin connector the last green white and orange remain the same. The first pair of two wires and the third pair of wires go into the turret gun assembly.

[Tiggr]

This is what my Taigen Tiger looks like....

The three pin plug looks as though it is the key. One of the wires is a common.

[c.rainford73]

Very interesting. I think the secret lies under that Taigen board we can compare it to the t90 upper hull board I have and trace the wires coming and going

[HERMAN BIX]

I hope to have one of those Taigen Tigers come and visit me on Sunday so I can plug my unit into its radio & cycle the mechanism on my JT to get the barrel in the forward battery.
Plus I can substitute my new HL radio onto the Taigen visitor to see is I can make it function like normal.
If so, I can confirm the need for the stuff from Haya and confirm the order.

[Tiggr]

Okay - the 3 pin plug on my last picture above - turn it round (this is on a Taigen Tiger)
Now I get the main gun to fire by moving the left stick horizontally to the right.
No gun sound effect though......
It's not right but it does fire the main gun.

[Tiggr]

I have taken the T90 sound board out of my Tiger 1 and reverted back to the original Taigen board.

I thought, right, I'll put the new T90 board into my HL Königstiger - after all it is KT sound.

So I opened up the KT and swapped the board, which should, in theory be a straight swap and all should work straight away.
Alas no. It doesn't
All works except the main gun - the reason is that the plugs on the underside of the top section next to the 8 pin socket are different.
My KT has a 2 & a 3 pin socket next to the 8 pin.
The new T1 has 3 number 2 pin sockets next to the 8 pin.

Stumped again
Officially pissed off with HL boards and the inconsistencies in their tanks.

[HERMAN BIX]

Get anew cable and 8 pin plug from HAYA U.K.
She'll work then