Torro Heavy Metal King Tiger

[hotte8487]

exelent build tread . Lovly details .Really like the fender details , were you can take them off as you pleez .

When New Battle ground is ready, pleez show video

Hello Stian,

nice to hear or better read from you. I've added our website address into my signature; so you can follow at each time our hard work with our new battle ground.
I myself be not the right man to make videos, but we have a buddy who can do that. But some time will pass until then...

[hotte8487]

Good morning, Hotte,
Keep an eye out at the first of the new Year for a notice to open photo submissions for January. Then, go to the thread and drop in your six best photos of the tank and that's all there is.
regards,
Painless

Good morning Painless,

I think outdoor photos are recommend. Because my kingtiger were finished late in this year it could be, that not so many photos are available. I will see...
But I also have a Panther, from this vehicle are many photos available. Maybe I start with him. I wish you a merry christmas and a good slide into the new year.
Thanks for these instructions.

[Jussek]

hi Hotte

i hope you can help...

...
The old gun cradle was placed too far from the front plate; so that during negative elevation the gun mantlet lay down on the upper hull.
I’ve thought a while about my gun cradle und than I’ve began. The original gun mantlet/cradle was not possible to dismantle; both parts were glued together. This connection I’ve separated directly before the recoil unit.
For the new gun cradle was used a big brass tube were my gun mantlet together with the leading tube fits sucking. Two smaller brass tubes for the one half of the bearing; both parts were how to see together soldered..…

in this thread i ask about the same problem that you found too

viewtopic.php?f=1&t=24383&p=227104#p227104

can i ask you how did you separate the parts of the gun shield, cradle and gun tube??

thank you very much mate!

best regards