RX18 wsn t34

[Dragon245]

Fitting a RX18 board into a WSN t34, can anyone tell me where the balck and red wire for the muzzle flash fit on the board :-\

[BREL]

have a look in this topic that I created about fitting an RX 14 board instead of the WSnN electrics
http://www.rctankwarfare.com/Forums/ind ... 856.0.html
I could not figure it out so I fitted a micro switch to the side of the main gun and wired it to the motor terminals as the motor is on when the gun recoils the switch is set so that the led flashes before the current stops to the recoil motor.motor

[Dragon245]

found this pic ,any idea which pins to connect tofor muzzle flash

[Dragon245]

ooops try again with pic