Would this do the job?
http://www.ebay.co.uk/itm/Tamiya-Educat ... 41a57fa7c2
Transmissions for narrow hull
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
-
jackalope
- Lieutenant
- Posts: 3882
- Joined: Fri Jun 20, 2014 7:42 pm
- Location: Communist State of Maryland, United States.
Re: Transmissions for narrow hull
I'm currently using this gearbox in my 251 build and it's a nice little piece for the money.
However a few things to warn you about.
1st it's open on both the top and bottom so you will need to cover it so debris stays out.
2nd the motors are 4 volt max motors so you need to either get higher voltage motors or figure a way to cut the voltage going to them. I'm running a 7.2 volt battery to an IBU2 that is turned down to 60% forward, 40% reverse power.
However a few things to warn you about.
1st it's open on both the top and bottom so you will need to cover it so debris stays out.
2nd the motors are 4 volt max motors so you need to either get higher voltage motors or figure a way to cut the voltage going to them. I'm running a 7.2 volt battery to an IBU2 that is turned down to 60% forward, 40% reverse power.
