
You'll still need to shave a few mm off the shaft length if you want them to squeeze into a Panzer 3 chassis

As you can see in the pic above its a very tight squeeze, but they will fit, eventually, and give a definate performance increase
Their the taigen low profile 5:1 black steelBarryC wrote:Mitchell,
What make gearboxes are those?
TIA,
Barry
Thanks for the heads up bud. I actually have a piece of perspex between the motors in each chassis, took it out for the picture. One chassis is running through a Clark board while the other is now running on an IBU2.971wright wrote:Hi Had some of these fitted in a Tiger , the 6v motor speed 400 draw more amps than the 7,2v version ,it could fry an rx18 mine did but it was in a Tiger full metal lower, might be O.K. in a Panzer 3 hull. Little tip slide a piece of plastic between the terminals just in case the chassis flexes stop them touching the other motor.
regards pete