Gig's 1:16 FCM F1

[Giganaut]

little update on the tank

setting up printing panels on how much i can fit in one print aaaand here is as far i can make for now. this is minus the track pieces

[Giganaut]

soon. project schedule shall commence in mid april

[Giganaut]

started up the printing sessions. this is merely the front glascias plates and the roof of the hull. note that there will be 2 turrets and also another part of the hull's length is till printing and will be done soon. now will move to the lower plates

[PainlessWolf]

Good morning, Giganaut,
This is a pretty amazing undertaking! If I can ever source tracks, I'll come talk to you about a Char B-1. That's been a fave French tank for a while.
Following along!
regards,
Painless

P.S. pretty much going to go with the Tamiya for the new KV-2 build with your turret. ;o)

[Giganaut]

i may need to redesign the tracks for easier printing and give it a stronger structure rather than having the track pins being the ones for the sprocket to drive with.

[Giganaut]

Good morning, Giganaut,
This is a pretty amazing undertaking! If I can ever source tracks, I'll come talk to you about a Char B-1. That's been a fave French tank for a while.
Following along!
regards,
Painless

P.S. pretty much going to go with the Tamiya for the new KV-2 build with your turret. ;o)

you might need to custom cut the track pins too. the length of the track links dont match the ones HL or tamiya makes.

ooh! awesome and i would like to see progression of it hehehehehe

[Giganaut]

progress and see the total length of the main hull!

[PainlessWolf]

Good morning, Giganaut.
If you print those tracks out, you should have a price for 'assembled' and 'kit' ;o)
regards,
Painless

[Giganaut]

Good morning, Giganaut.
If you print those tracks out, you should have a price for 'assembled' and 'kit' ;o)
regards,
Painless

but first i need to perfect it without having it too rough to flex between links hehehehe

[Giganaut]

slow n steady