Bristol Armoured Division

[wibblywobbly]

Ok, I have contacted the organiser's, and will await their reply.

..and just to prove that I don't watch daytime tv...

...and this now self centres.

...and the 1/16 jeep project is well underway.

jeep.jpg (40.71 KiB) Viewed 2596 times

and tomorrow I might build a couple of Jagdpanther IV's, they don't take five minutes so I'll knock up a couple and see what they look like!

[silversurfer1947]

Great stuff.

[Bogeyman]

Very good Rob, and for your next trick ?

[wibblywobbly]

The show invitations will be going out at the end of the month, and they we will be welcome. I will let you all know more as soon as I know.

Rob

[wibblywobbly]

If anyone by the name of Andy ever says to you 'here, take this Tiger and see what you can do with it'....poke him in the eye with pointed stick and run, keep running, do not stop, not for anything!

....to be continued....

[silversurfer1947]

It's already changed out of all recognition!!

[TKcommander]

I had to poke myself in the eye to make sure I was seeing things correctly!!!!!!!

[silversurfer1947]

I hope the stick wasn't too pointed

[wibblywobbly]

Its not often that I post pictures of my rear end on a forum but here we are anyway!

...to be continued...

[wibblywobbly]

1/18 vs 1/16

After a lot of faffing about I finally got two halves of a 1/16 jeep, it will be faced up with 0.5mm styrene which will make it 1mm oversize, but hey, that's my stupid fault for concentrating so much on cutting the model into two halves and reducing the print time as much as possible. This mess still took 6 hours! To print a solid bodyshell would have taken 18??