Blowing Fuses

[ONeal]

My Tiger is blowing the lil 2 amp fuse. Last week I was doing a trial run and it blew while tank was moving and I fired the cannon.
I checked all the wiring and put a switch between battery and IBU2. Today it blew the 2nd one a minute after crank up. the 3rd before it actually cranked. Any thoughts, recommendations? I'm out of fuses.

running dual Tarrs off 5th channel using step-up converter @ 7.2v
amp w dual matos, and a visiton

Neal

[MichaelC]

Not an IBU2 user, but I rigged up a fuse setup using the same glass blown fuse on the power line in to the Clark board. I find that I need a minimum of a 3A fuse for normal use, and sometimes up to 5A. I don't know what the power rating is for IBU2, but I think it is the same 20A rated for the motors so it would be similar.

[ALPHA]

Not an IBU2 user, but I rigged up a fuse setup using the same glass blown fuse on the power line in to the Clark board. I find that I need a minimum of a 3A fuse for normal use, and sometimes up to 5A. I don't know what the power rating is for IBU2, but I think it is the same 20A rated for the motors so it would be similar.

ALPHA

[KTRob]

My Tiger is blowing the lil 2 amp fuse. Last week I was doing a trial run and it blew while tank was moving and I fired the cannon.
I checked all the wiring and put a switch between battery and IBU2. Today it blew the 2nd one a minute after crank up. the 3rd before it actually cranked. Any thoughts, recommendations? I'm out of fuses.

running dual Tarrs off 5th channel using step-up converter @ 7.2v
amp w dual matos, and a visiton

Neal

Hi Neal, according to my IBU2 manual, the 2A fuse is for the servo circuits? do you have recoil/elevation on a servo?

If not maybe somethings shorting the servo pins on the board?

Hope this helps

[Tankbear]

running dual Tarrs off 5th channel using step-up converter @ 7.2v
amp w dual matos, and a visiton

Neal

If your powering the TARR's and step up from the receiver that is why, your pulling too much power.

With the IBU2 the 2A fuse protects the IBU2 and servo outputs and receiver all which run at 5v or 3.3v. The larger fuse protects the outgoing motor circuits.

Ian.

[ONeal]

OK My thinking was run it off recvr and save some battery power using the step up. Sooo.... just wire the tarrs to the battery with a switch? Neal

[ONeal]

Glad I caught you online its 7:45 am in Alabama what time is it there?

[Tankbear]

Yeah connect them to battery rather than receiver.

[jarndice]

Neal, In the UK we are 6 hours in front of you.
Which means you caught Ian at his after lunch Sherry,
shaun

[jackalope]

Neal, In the UK we are 6 hours in front of you.
Which means you caught Ian at his after lunch Sherry,
shaun

Is Sherry hot? Pics or ban!