Boosting a H.L. smoke unit
Forum rules
If you're planning on posting a log of your build please use the relevant build sections.
If you're planning on posting a log of your build please use the relevant build sections.
- Muscleflex
- Lance Corporal
- Posts: 165
- Joined: Thu Sep 03, 2015 7:54 am
- Location: West Yorkshire, UK
Re: Boosting a H.L. smoke unit
Can I still buy this smoker? I know nothing about smoke units. Will it be ok for my tamiya tiger?
Re: Boosting a H.L. smoke unit
Of course you can get that smoker..check with forgebear....but really I would get the TARR 1...all metal construction and puts out ten times more smokeMuscleflex wrote:Can I still buy this smoker? I know nothing about smoke units. Will it be ok for my tamiya tiger?
Get new exhausts from forgebear...you'll need those
ALPHA
- Muscleflex
- Lance Corporal
- Posts: 165
- Joined: Thu Sep 03, 2015 7:54 am
- Location: West Yorkshire, UK
Re: Boosting a H.L. smoke unit
I'll contact him now. So I just ask for tarr 1 smoker unit with exhausts?
Re: Boosting a H.L. smoke unit
I don't think he carries the TARR....he does carry the stock HL or Taigen units....The Tarr over there I'm not sure of...I got mine from Dgsselkirk...also a member here...not sure if he has any left...but you can try contacting him...or ask Forgebear if he can source them for you from himMuscleflex wrote:I'll contact him now. So I just ask for tarr 1 smoker unit with exhausts?
ALPHA
- Muscleflex
- Lance Corporal
- Posts: 165
- Joined: Thu Sep 03, 2015 7:54 am
- Location: West Yorkshire, UK
Re: Boosting a H.L. smoke unit
Thanks. Is it the TARR 1 or TARR mk2 I need to be looking at?
- Muscleflex
- Lance Corporal
- Posts: 165
- Joined: Thu Sep 03, 2015 7:54 am
- Location: West Yorkshire, UK
Re: Boosting a H.L. smoke unit
Great! Thank you!
Re: Boosting a H.L. smoke unit
Hello!
I have a problem with HL proportional board that im trying to work with my Tarr smoker.
I dont get the voltage out from the motors to the fan. I Think its like this that the voltage from the RX board is constant to the heater element and the voltage from the motors should affect the pump/fan when the voltage get over the RX board. But all i got when i measure at the fan Points when i got 8V from the motor Point is the voltage that same that came from the RX board. Hope you understand my problem. See Picture. Do i need to jumper some Point at the board??
//Sebbe
I have a problem with HL proportional board that im trying to work with my Tarr smoker.
I dont get the voltage out from the motors to the fan. I Think its like this that the voltage from the RX board is constant to the heater element and the voltage from the motors should affect the pump/fan when the voltage get over the RX board. But all i got when i measure at the fan Points when i got 8V from the motor Point is the voltage that same that came from the RX board. Hope you understand my problem. See Picture. Do i need to jumper some Point at the board??
//Sebbe