Re: bb gun.

afv · Post by **afv** » Sat Feb 14, 2009 1:19 pm

Howdoo,
can anyone tell me if the rubber washer in the bb unit fits over the barrel or just butts up against it ( no i'm not fitting the straw in the barrel, it was just to use in place of in the photo )

thanks and regards
Jack.

971wright · Post by **971wright** » Sat Feb 14, 2009 1:23 pm

Hi Afv the rubber washer fits into the barrel it holds the BB in place and acts as a seal cant rememeber which way round it goes .

regards pete

971wright · Post by **971wright** » Sat Feb 14, 2009 3:11 pm

Its looking very nice .

regards pete

madbadger · Post by **madbadger** » Sat Feb 14, 2009 4:28 pm

if my memory serves me right, i think it just butts up to it. Its a while ago since i stripped my BB gun, had to buy another BB unit as i pushed my metal barrel down to far and split the washer, the gun wouldn't fire after that, no seal so the air couldn't get behind it.

Kev

NigelDerEnglander · Post by **NigelDerEnglander** » Sat Feb 14, 2009 5:59 pm

As displayed in the picture, the rubber washer is the wrong way round. The flat part butts up against the barrel and the tapered section gets stretched to form a tight seal when the tapered breech nose pushes the BB into it.

Nige