Tiger I RC Tank Metal Driveshaft Supports Brass Bushes 8.06m

[ruben2005]

hi all , have a lot of play in my sprocket on left side so got these to fit do they go inside the hull or out many thanks

[spongehoobtank82]

Outside dude

[jarndice]

Ruben Hi, If you go to "TIPS & TRICKS" then go to SUB PAGE "4" scroll down you will come to "Axle support bearings" if I say so myself it is quite helpful. shaun

[ruben2005]

thanks fellas

[jarndice]

Ruben, The axle support bearings have two holes in them so you can screw them in place against the hull,
Make sure the holes in the hull are placed so you can get access to the screws so you can fit the nuts, because the gearboxes do get in the way!!!
If your Hull is fitted with axle covers, they will need taking off before the support bearings are fitted, a liberal application of debonder will do the job and after you have cleaned everything just refit. shaun

[ruben2005]

thanks for your help jarndice got these as a last resort to get rid of the track and sprocket problems i have on my taigen metal hull tiger1. reading some posts on here im not the only one to have this problem and its my left side as well but massive thanks for your help fella