HL tiger turret with recoil and flash

[971wright]

Trying to down load the pdf files this converts Heng Long to tamiya compatable very cheap conversion .

regards pete

[971wright]

Here is the second one managed to down load them thanks to Matt upping the download limit so you guys can now download these files and take a look at them for yourself.This one is more expencive but has more features and sound card


      regards pete

[BREL]

well done to Pete for putting the files on here

[tankman]

Hi BREL hope you can help me here. I have an asiatam recoil unit in the "paper Panzer" project. I am having a small problem wiring up the flaming thing. Got the black to battery negative bit ok. Sorted the red, green,yellow from the recoil to the H/L black,red,black  ( it's  recoil yellow to H/L yellow  recoil red to H/L brown and recoil green to H/L blue thank's YHR ). Where I have a problem now is the white and blue wires that come off the elevation and recoil motors. These are suposed to go to the old airshot motor on off switch and acording to the instlation disk pictures the wire with the attached resistor is suposed to connect somewhere can you throw any light on this arangment as I want to get the RX 18 board up and running the tank this week ready for painting next week. the Tiger is looking good and one can see you have spoilt her with a lot of nice upgrades. Please keep the pictures coming. All the best for now
Alan 

[BREL]

I am sorry I should have pointed out that the recoil unit came ready built into the turret that I got fro millitarymight and had only 4 wires in black sleeving coming out of the turret one for the return to Battery neg and the three that attach to the little pcb where the airsoft gun and elevation motor are connected it will run of the RX 18 board via the connector on the under side of the top hull.

tank man I just connected the blue and white to either side of the switch and ignored the resistor

[tankman]

Cheer's BREL I will give that a go then. All the best for now
Alan