hellllllp

jackalope · Post by **jackalope** » Mon Apr 06, 2015 3:59 pm

No no. Your tank already has the adjustable tensioner right?

We'll get it fixed today relax, I got this.

jackalope · Post by **jackalope** » Mon Apr 06, 2015 4:04 pm

You there Ed? Do you have an allan/hex head screw driver that will fit those little screws that hold in the axle?

jarndice · Post by **jarndice** » Mon Apr 06, 2015 4:05 pm

Ed go to
http://www.matomart.com
select Tank accessories and click on Tiger 1 and go to mato upgrades then select sub-page 5 and you will see the idler I was talking about.
I have dealt with Matomart before and they are OKAY.

shaun

edpanzer · Post by **edpanzer** » Mon Apr 06, 2015 4:08 pm

jackalope wrote:You there Ed? Do you have an allan/hex head screw driver that will fit those little screws that hold in the axle?

no I will buy some Wednesday as I'm off for the week from then. Its a Taigen not a mato

hawkeye3guns · Post by **hawkeye3guns** » Mon Apr 06, 2015 4:10 pm

Hi Ed its Denzil at Grantham I might have some 2mm screw's in the garage. If you can not get it fixed bring on sunday and I'll bring a selection of screw's with me
regards Denzil

edpanzer · Post by **edpanzer** » Mon Apr 06, 2015 4:15 pm

Thanks...I've emailed Dom at RCtank.de hope fully it will get sorted one way or the other....the wife has hidden my hammers

and the smallest easyout I have is about 20 times too big lol

jackalope · Post by **jackalope** » Mon Apr 06, 2015 4:21 pm

Ed, just the 2 halves of the wheel seperated because the 3 screws fell out correct? Once you get an allen head screwdriver you can loosen the allen head screw that holds the axle in so you can remove the whole axle and inner half of the wheel. Once you get the inner half of the wheel off you can put new screws back in or like I said Crazy glue the inner and outer halves together where the axle pin DOES NOT ride. You don't want to get Crazy glue in the axle pin or the wheel won't spin.

Heck you can Crazy glue it back together now without having to remove the inner half or the wheel.

jackalope · Post by **jackalope** » Mon Apr 06, 2015 4:23 pm

Ed unless I'm looking at the pics wrong you are WAY WAY over thinking this.

jackalope · Post by **jackalope** » Mon Apr 06, 2015 4:39 pm

Well I tried, best of luck to you Ed hope you get it fixed.

edpanzer · Post by **edpanzer** » Mon Apr 06, 2015 4:53 pm

Jack you are right there isn't ANY screws I took the track off the other side and the idler wheel pulls apart that side too I have glued them together and its fine now... Many apologies to all I really didn't think they would just push together

RC Tank Warfare community hobby forum

hellllllp

Re: hellllllp

Re: hellllllp

Re: hellllllp

Re: hellllllp

Re: hellllllp

Re: hellllllp

Re: hellllllp

Re: hellllllp

Re: hellllllp

Re: hellllllp