advice needed

[trooper4rtr]

advice needed,could any one please tell
me how to remove idler wheels from HL tiger
E.mail thanks.  MICK

[Ex_Pat_Tanker]

With great care! They're basically just a press fit - you might be able to tap them out from inside, but probably best to gently prise them out, I was replacing the idlers on one of mine with metal ones any way, so I could afford to be brutal and smash the idler out of the way and then pull the pin from the outside!

[Andicog]

Depends , later Heng Long Tiger has a small hole in the centre of the idler wheel, use a thin pozi/philips driver through the hole to remove the self tapper.If its an earlier one then I found removing the tracks and using a thin blade to seperate the two halves of the idler wheel then gripping the end of the axle with pointed pliers and gently twisting it out. Later idlers have a metal bush pressed into them and the centre hole is a larger diameter, think they are 4mm i/d while older ones are 3mm i/d . 

[trooper4rtr]

thanks to you all for your advice,found thay had,
philips screws,have removed now,thanks again, MICK