My taigen tiger fires continually.

[Paffs007]

My tiger fires continually. The up/down movement is a bit jerky too. Any ideas?

[lister fiend]

errrr.....
make sure the micro switch is plugged in & opening & closing properley
does it have the asiatam recoil & elavation unit installed?

[Paffs007]

Hi. Not sure which gun it has fitted. Am new to this so bit of a novice. How can I check to see if the micro switch is opening?

[lister fiend]

have you split the upper/ lower hull?
if not do so.
then look up the hole in the turret gear.
if there is a rounded plastic bit poking through, it is a normal unit.
if it's a white oblong shape that's tucked up inside it's the taigen recoil unit.
right, if you have the former.
on one of the sides will be a small micro switchwith 2 wires that should run to pins 4 & 5 on cn3 (mg fire)
oh, assuming you have an rx 18
proberbly best if you split the the hull & take a couple of photos of it

[Paffs007]

Hi I've took a photo of the inside of the turret but don't know how to put it in my post..

[Paffs007]

Hi I've took a photo of the inside of the turret but don't know how to put it in my post..

[lister fiend]

hi, i use photo bucket & just copy the img then paste
simples

[lister fiend]

the white bit inside the turret gear is the airsoft unit.

the red & black wires at the back of the airsoft unit is the microswitch.
don't bother looking where it's plugged in though because this one is in a clark board.
hope that helps
lister

[Paffs007]

Hi your white pic looks the same as the one I have.

[Saxondog]

Make sure the 8 pin connector is plugged into the receptacle correctly, it can be installed backwards.