reducing voltage
reducing voltage
hey guys can someone please tell me how to reduce 8.4 or 7.2 battery packs to around 4 volts for lazer power?iwant to use the lead to the turrent l.e.d. for power thanks for any help j
Re: reducing voltage
I think the power to the turret led is 3 - 4v so there's no need to lower it.
Re: reducing voltage
i checked it with volt meter it is 7.2 with current batt,the lLED lead comes off gun motor........LED had a resistor on it to reduce power to LED i guess but i wasnt paying attention and cut rite on it....pays to have good lighting
Re: reducing voltage
how about this item:
Last edited by IMPACT on Wed Jan 14, 2009 11:14 am, edited 1 time in total.
- tiger205
- Warrant Officer 1st Class
- Posts: 1800
- Joined: Thu Oct 23, 2008 11:21 pm
- Location: southampton
Re: reducing voltage
hi impact, that looks a great bit of kit, i could use that for the HL smoker into an elmod setup, how much is it and where can you get it?
Tony
Tony
"Er, der kämpft und Lebend davonläuft,
Lebt um einem anderen Tag zu kämpfen".
Re: reducing voltage
Hi Tony,
yes, it is small.
The PCB measures 20mm x 30mm. The total height (measured to the wire clampers) is 12mm
From the simple Voltage table, when the INPUT (Battery source) is more than 7.50V (up until the maximum of 15V), the OUTPUT (@ max) will regulate and hold at 6.45V.
To cut the cost down, this item is marketed without a casing, but a double side tape is included to paste at the soldering side.
IMPACT only sells direct in at Asia. You can inquire at our Distributors, they will provide you the price.
THanks
yes, it is small.
The PCB measures 20mm x 30mm. The total height (measured to the wire clampers) is 12mm
From the simple Voltage table, when the INPUT (Battery source) is more than 7.50V (up until the maximum of 15V), the OUTPUT (@ max) will regulate and hold at 6.45V.
To cut the cost down, this item is marketed without a casing, but a double side tape is included to paste at the soldering side.
IMPACT only sells direct in at Asia. You can inquire at our Distributors, they will provide you the price.
THanks
Last edited by IMPACT on Wed Jan 14, 2009 2:06 pm, edited 1 time in total.