TK-TX11P Transmitter PCB

Discuss the good old Heng Long electronics here, whether its mods on them or anything else, it goes here!
Post Reply
User avatar
Storky
Private
Posts: 98
Joined: Wed Nov 10, 2010 2:58 pm
Location: Plymouth

TK-TX11P Transmitter PCB

Post by Storky »

Hi All

Have just resoldered the battery wires to the PCB in my sons' Henglong Long 27Mhz transmitter. Now for some reason it no longer works. I have tried fiddling with the crystal etc, but still no life.

Does anyone have any ideas please? It was working fine last night!

I hope I have posted this in the correct thread!

Regards

Phil
If you are not living on the edge, then you are taking up too much room.
Top
afv
Lance Corporal
Posts: 227
Joined: Mon Oct 20, 2008 5:18 pm

Re: TK-TX11P Transmitter PCB

Post by afv »

Might be the batteries, i found that the batteries are not all the same size especially the aa rechargeable type. Make sure the little nub on the positive end of the battery is making contact with the metal tab in the controller and check they make contact where the spacers are down the centre of the battery conpartment

regards Jack.
Top
Post Reply

Return to “Heng Long”