lower hull bulge

[painkiller]

thanks for the tips,answer to your question painless wolf,yes there is usually a gap on the jagdtiger,something i also wasnt happy with so some carefull trimming has hopefully sorted that out,going to have a go tonight so will post pictures over the weekend.

[PainlessWolf]

Good Morning,
Sounds great!, Painkiller. Looking forward to pictures of these two Beauties zim'd, repainted and tracked and on the move. ;o)
regards,
Painless

[ALPHA]

thanks for the tips,answer to your question painless wolf,yes there is usually a gap on the jagdtiger,something i also wasnt happy with so some carefull trimming has hopefully sorted that out,going to have a go tonight so will post pictures over the weekend.

If you have a decent blow dryer with cold shot.... after you trim the edge of the hull... heat it a little... push it down... then cold shot it so it will stay

ALPHA

[painkiller]

best i could do,it is almost like the top hull is a couple of mill shorter than it should be

tigers 004.JPG (50.56 KiB) Viewed 1711 times

tigers 005.JPG (51.69 KiB) Viewed 1711 times

tigers 006.JPG (48.49 KiB) Viewed 1711 times

[ALPHA]

Another tip for taking care of the gap... add a little plasticard to whichever side requires it.. maybe creating a 90 degree tuck on the upper hull... and a little addition to the bottom ... so when the top seats... it will appear sealed .... sand it flush and you should be good

Nice job on the touch up

ALPHA

[ALPHA]

I know this is out of the usual ... and I don't want to sound critical... but your netting... when I look at it hanging over the nose of the hull... it makes me think of those bad tattoo coverups ...perhaps a piece of stained wood and some sandbags might be a better look

ALPHA