HELP electronics
- raven
- Warrant Officer 2nd Class
- Posts: 1042
- Joined: Mon Dec 29, 2008 8:27 pm
- Location: dublin ireland
HELP electronics
hi i have stripped out my matorro KT electronics and put in new h/l gearboxes rx18 board i looked at a rx18 diagram to make sure i plugged it in right, i dont have the upper hull connected yet but should the motors and start up sound work without the upper hull connected
chris
chris
Re: HELP electronics
not a problem chris the answer is yes you can even run it without the upper connected with no worries
- raven
- Warrant Officer 2nd Class
- Posts: 1042
- Joined: Mon Dec 29, 2008 8:27 pm
- Location: dublin ireland
Re: HELP electronics
forgot to mention im still useing matorro on/off switch
- raven
- Warrant Officer 2nd Class
- Posts: 1042
- Joined: Mon Dec 29, 2008 8:27 pm
- Location: dublin ireland
Re: HELP electronics
have switched it on nothing
chris
chris
-
- Corporal
- Posts: 431
- Joined: Mon Dec 28, 2009 6:34 am
Re: HELP electronics
OK, first things first.
check to make sure that the battery is definitely charged and good.
Check to see that the battery feed is connected correctly into the rx 18 board. Also make sure the volume knob is connected correctly and is turned up. There will not be any sound without that knob connected.
check to make sure that the battery is definitely charged and good.
Check to see that the battery feed is connected correctly into the rx 18 board. Also make sure the volume knob is connected correctly and is turned up. There will not be any sound without that knob connected.
"All truth passes through three stages. First, it is ridiculed. Second, it is violently opposed. Third, it is accepted as being self-evident."
Re: HELP electronics
Having put in the RX18, are you also using a Heng Long Transmitter? - I don't think Matorro transmitters are compatible although physically the same.
- raven
- Warrant Officer 2nd Class
- Posts: 1042
- Joined: Mon Dec 29, 2008 8:27 pm
- Location: dublin ireland
Re: HELP electronics
hi have checked all plugged in the KT has no sound control knob, i took out on/off switch lead connected it to one of the motors and it worked then plugged it back in still nothing
chris
chris
- forgebear
- Warrant Officer 1st Class
- Posts: 1812
- Joined: Fri Nov 21, 2008 11:15 pm
- Location: bedford
- Contact:
Re: HELP electronics
hi there you are right the transmitter needs the heng long main board in side it to be compatible
- raven
- Warrant Officer 2nd Class
- Posts: 1042
- Joined: Mon Dec 29, 2008 8:27 pm
- Location: dublin ireland
Re: HELP electronics
yes im useing h/l controller
- raven
- Warrant Officer 2nd Class
- Posts: 1042
- Joined: Mon Dec 29, 2008 8:27 pm
- Location: dublin ireland
Re: HELP electronics
its working now after i put in sound control knob im useless at these electronics and thanks for all your help guys will get back to you if i have any more problems
chris
chris