RC Tank Warfare community hobby forum

Hello there. Could anyone tell me if the "Atak Model zimmerit sheets for Tamiya King Tiger Production Turret 1/16 scale" sold by Welshdragon can be adapted to fit the Torro KT?

Thanks for any help/advice.

Shane.

Hi,
I am only guessing but since they are both the same scale they ought to fit.....also Steve at Welsh Dragon is a member on this Forum... so I would say 'Just ask him' and see what he says....he is an Honest bloke and I am certain that he will give you an Honest and informed opinion....He does sell the Torro KT...here..
http://www.welshdragonmodels.co.uk/king ... -145-c.asp
So if he doesn't know, then it should only be a minute or two to measure a set up against the actual model....
Alb.

Thank you, I'll fire off a PM to Steve and see what he suggests.

Hi
........To answer your question...sort of.....I was looking for some info on Torro Electronics for another member and found this thread...which gives you a perfect 'How To Do It..'...On page 2 of the post from the 8th post down by 'jukebox'.....he has fitted the ATAK Zimmerit to a Torro KT......
http://www.rctankwarfare.co.uk/forums/v ... 9&start=20
Alb.

Brilliant! Cheers for finding that, will help me a lot.

They are a nice looking bit of gear thinking of buying the upper hull for my torro lower hull that I already have...

Need to wait a few weeks for the Zim kit to be in stock, so got time to prepare paints, accessories, etc. Going to attempt airbrushing myself, but the smaller kit will have to be bought in, so pre-painted Gucci kit is now on the list!