You can buy seperately (which I did) plastic cover caps for them. I then fixed small chain to the caps and soldered the other end of the chain to the dischargers.
Re: Leopard 1A4
Posted: Tue Oct 02, 2012 5:07 pm
by sparks
I saw these rotating beacon lights from a company called Pistonking, I was so impressed by the reality of the operation that I wanted one to replace the beacon light on my Tamia Leopard 2A6, not sure if the Leopard 1,s had them, but as I said, I liked it so much decided to add one anyway.
Made a couple of antenna's from piano wire to replace the stubby little ones in the kit.
Painted and fitted the upgraded metal MG and carrier.
Re: Leopard 1A4
Posted: Sun Oct 14, 2012 11:38 am
by sparks
Eastern Front wrote:Sparks,
Yes the leo 1 had them as well, it is required in Germany when your on any of the roads for safety..
Cheers!
Thanks mate,
Thought that might be the case (but it was staying anyway )
Re: Leopard 1A4
Posted: Fri Nov 02, 2012 11:22 pm
by sparks
Sorry, not much happening at the moment. Over the last couple of evenings I've been having a go at the PE side boxes.
Formed the basic box and soldered the joints, then soldered a 0.6mm rivet through the 4 holes in the base.
then I soldered a 0.8mm brass nut over the rivet on the underside so that when fixed to the tank hull the box will spaced off like the real thing.
Hinges and clasps.
Will paint tomorrow and fit to hull.
I am tempted to make the barrel cleaning rods, I have the PE holder and brass rod that I can thread with small taps and dies.
Re: Leopard 1A4
Posted: Sat Nov 03, 2012 11:46 am
by sparks
Side boxes on.
Re: Leopard 1A4
Posted: Sun Nov 04, 2012 11:14 am
by Andy in Cheltenham
It always puzzled me as to why Tamiya had the X part raised instead of how yours are.
Re: Leopard 1A4
Posted: Sun Nov 04, 2012 3:45 pm
by doc larsson
amazing ! and insanely detailed.
nice
Re: Leopard 1A4
Posted: Sun Nov 04, 2012 10:06 pm
by sparks
Thanks Doc,
Andy, thats why I wanted the PE boxes, perhaps its easier to mould with the X raised. Or they put the mould in back to front
Re: Leopard 1A4
Posted: Sat Nov 17, 2012 12:39 am
by sparks
Put the PE barrel cleaning rod holder together.
I have ordered some working wing nuts to finish it off.
Re: Leopard 1A4
Posted: Sat Nov 17, 2012 12:40 am
by sparks
Put the PE barrel cleaning rod holder together.
I have ordered some working wing nuts to finish it off.