RC Tank Warfare community hobby forum

hope you like. i know the jack block is wrong , but i only realised after i'd done it and i liked it too much. and i think the dots are too big, but apart from that, what do peeps think?
jeff

Looking good already fella, Zim is spot on. How do you intend to go about weathering, light or full on combat mucky?

looks awsome! how do you get the zimmerfit on the tank is it a kit or did you do it yourself?

Looks great Jeff gotta be happy with that and the dots look fine to me also.
Cheers Ken

going to be full on combat dusty, not too much mud as mines a what if, as if the tank has survived to the battle for berlin, so lots of concrete and brick dust. got an airbrush so that should make the final mist coats a lot easier. did the zim myself with milliput and a small screwdriver. worked out there is between 2500 and 3000 litle impressions. went cross eyed a bit. lol
jeff

miliputt? where can i get this the effect looks proper good

mulliput from your local model shop. rub the surface its going on down, so you have a key. mix your milliput, using latex gloves and keeping them wet. put small peices on at a time and smooth thin with the wet gloves. once you do one side then use a terminal driver , wet it, and just work your wat up in lines imprinting the tip. only takes time. it was my first time using milliput after 30 odd years of modelling and it wasn't as bad as i thought it would be.
jeff
ps i think i have another thread showing it before i painted called the zim is done, thank god

forgot to ask n1ghtpony, where abouts are you?
jeff

streetfighterjeff wrote:forgot to ask n1ghtpony, where abouts are you?
jeff

swansea wales mate ,lovin them sheep lol

ah well should be fairly easy to get milliput. any hobby shop will sell it and some diy places.
jeff