HL Panzer IV F1 upgrade
Posted: Mon Jan 23, 2012 5:23 pm
Hi Guys
I hope I have put this in the right place?.. Just starting the upgrade to a Dak Panzer IV F1,The lady friend gave to me for Xmas, my reflexes are getting too slow for Helos now! lol,
It is a non Smoke & Sound Airsoft and didn't run out the box so I thought, Upgrade it! If I can build motorcycles i can do this????
I have started fitting, RX18 MFU and took the opportunity to fit a cooling fan to the RX18 as per instructions found in another post here,I also took a another excellent tip of fitting fuses to the power in and motors( red wires).
Sound is to be standard HL for now, smoke (HL the unreliable one, but again this forum has furnished me with enough info to build one at a later date), upgraded reciever and tranny to match(Sender Xtal units), 3.1 metal gearboxes, metal tracks, Adjustable rear idler and finally metal drive sprockets. Still loads to do! and, eventually I would hope to Detail it to as near "Field Spec" as I can manage!! Hands are a bit shaky at times for fine work! lol
I am keeping a photo record so when I master the uploading of same I'll post them up.
Just like to say a massive thank you to all of you whose contributions i am using. I am really enjoying this new hobby! I just wish there was something I could bring to the table!
Cheers for now.... Stewart (Triton)
I hope I have put this in the right place?.. Just starting the upgrade to a Dak Panzer IV F1,The lady friend gave to me for Xmas, my reflexes are getting too slow for Helos now! lol,
It is a non Smoke & Sound Airsoft and didn't run out the box so I thought, Upgrade it! If I can build motorcycles i can do this????
I have started fitting, RX18 MFU and took the opportunity to fit a cooling fan to the RX18 as per instructions found in another post here,I also took a another excellent tip of fitting fuses to the power in and motors( red wires).
Sound is to be standard HL for now, smoke (HL the unreliable one, but again this forum has furnished me with enough info to build one at a later date), upgraded reciever and tranny to match(Sender Xtal units), 3.1 metal gearboxes, metal tracks, Adjustable rear idler and finally metal drive sprockets. Still loads to do! and, eventually I would hope to Detail it to as near "Field Spec" as I can manage!! Hands are a bit shaky at times for fine work! lol
I am keeping a photo record so when I master the uploading of same I'll post them up.
Just like to say a massive thank you to all of you whose contributions i am using. I am really enjoying this new hobby! I just wish there was something I could bring to the table!
Cheers for now.... Stewart (Triton)