RC Tank Warfare community hobby forum

Hi Team, I am building a tiger 1 , I started with a HL S&S and there is not much lift. I have a new turret with recoil, flash and ir fitted I wish to remove the LED at the side of the main gun as it is no scale is this used for the IR I will only move it into the turret out of the way. Also I have a M/G to fit in the turret with a LED can I connect this to the one in the front of the hull. As you can see I dont do volts. Pete.

Hi Pete,

Not certain about the IR query. But the machine gun yes should be able too, you may find one gets dimmer and other is bright (as the LED are different) but the resistor is already sorted in the RX18 board.

I added front and rear MG LED to my KV-1 when I upgraded to the RX18 board just needed to add the wiring and LED's.

Hope that helps.

Your IR is only used in your main gun flash..the machine guns are just flashing LED's so you can have as many or a few of those as you want.