RC Tank Warfare community hobby forum

will a h/l tiger run on a

7.4V 2100mAh Lithium Polymer (Lipo / Li-poly etc) Battery Pack please help
has anyone tryed this

I run lipo in all my tanks I use 4000 mah lipos and i also you low voltage cut offs to prevent battery damage from running them to low

would the electrical side cope with them being 7.4v with out frying them
i have been told they are a better battery and longer running time
am more worried about the circuit boards cooking and burning them out
it's some thing to looking too have been looking at them
cheer's derek

7.2 or 7.4 realy makes no differance other than better run time the is a small increas in speed but no harmfull effects on the rx18 or tamiya boards

cheer's that's a great help to know that i can use lipo batteries for rc tank's
thank's bubbajoexx
Derek

Hi,

A fully charged NiMh pack gives out more than 7.2v anyway, the theoretical voltage 0.2v increase should make no difference whatsoever.
Bubba mentioned a low voltage cut off. One of these is pretty vital. If you over discharge a LiPo pack you will knacker it.

Peter

i was told about the motor side of it that there is a power increase
but the board side we was'nt to sure of
and thanks for the advice now i can start looking in to getting lipo batteries for it
Derek