RC Tank Warfare community hobby forum

hi all

ok ... so need help ... have a project in mind .. have the leo ... 2a6 .. but you all know me by now .. i just cannot do an out the box build ... for me that almost pointless ..
i had the leo sat around for 5 year or more ... and found a leo conversion that i will build .. by hook or by cruck .. it will get built as no one else in there right mind has attempted it

i have been pooring over the www for about 6 months ..plotting and plannng .. gathering info .. pics .... books ... and 1/35 kits and resin conversions ..

this conversion .. just has to be done .... but i need help

lotts of help ...



the help

i need help to work out how to make the bar armour ..... i have been looking at brass ... but the strip required would have to be made ..and cost about £350 befour i cut it up and ' try ' to solder together .... and yep .. never tryed to solder brass ...yet !
the other idea i am looking at is evergreen plastic strip ..... but just worried about the lack if strengh with plastic stripp

so ... any one got any ideas .. of how the heck i can make the bar armour

and thats just the beginning of this project .....

Think your best bet would be to talk to fv432, plastic would be too fragile and Rob's the Brass man

Use screen door mesh as a base, then ad strips to make the details like the angles at the rear corners. The bars could be added or cut out of the screen based on the detail your copying?

Hi,

have you thought about getting the bar armour etched in brass? I am not sure of the cost for this, but if you did the artwork, then it might be possible to then send that to a specialist company who could then etch it in brass for you. If you had spares you could then offer them for sale to others and re-coup the original etching cost as bar armour is really useful for modern tank modellers.

hi there Dylan

i have looked at brass etch .. the problem is brass cannot be eched deep enough and would also cost around £1000 . to do a one off

How about finding a very fine pastry cooling rack. normally metal it would be similar in style and maybe you could solder in some extra wire. Just an idea.

I would use copper, as copper is easy to braise, Start with a small sheet about A4 should do it, Nip of to your local fabricators and ask them nicely to Guilatine it up, about 2 to 3mm wide per stripp, If you made some sort of board cut grooves at 1.5 to 2mm deep at 3to 4mm apart, that would pruduce a matrix so you could slot the stripps in then braise.

Just thinking out loud